Chainsaw Gloves

Five-fingered glove with elastic cuff made of 0.9 – 1 mm thick waterproof green chrome-dyed cowhide. Yellow split leather. The left hand is made of a 135 g/m2 Criss-Cross position 12-layer anti-cut fabric, ref. NOR JERSEY. The anti-cut material is covered on both sides by a layer of yellow knitted fabric formed by 200 g/m2 interlock Kevlar and this outer layer in turn by another layer of 100% cotton composition fabric, Ref. “Canvas”.

The right hand is certified for mechanical risks and the left hand is certified for mechanical risks and for chain saws.

EN 420:03 – Protective gloves. General requirements.
EN 388:03 – Protective gloves against mechanical risks.
UNE-EN 381-7:00 – Protective gloves against Chain Saws.
MARKING: Reference, size, marking CE with logos and levels. Right hand with mechanical risks and left hand with mechanical risks and for chain saws.
SIZE: 7, 8, 9 and 10
EN 388
PROTECTION LEVELS
1
2
3
4
5
A) Resistance to Abrasion 100 500 2000 8000 —
B) Blade cut resistance 1,2 2,5 5,0 10,0 20,0
C) Tear resistance 10 25 50 75 —
D) Puncture resistance 20 60 100 150 —
EN 381-7
CUT RESISTENCE FOR A CHAIN SAWS
Class Speed Chain
0 16,0 +/- 0,2 m/s
1 20,0 +/- 0,2 m/s
2 24,0 +/- 0,2 m/s
3 28,0 +/- 0,2 m/s
USE

Handling during work with chain saws.NOT RECOMMENDED FOR
Never use them when there is a risk of trapping by mobile machines parts.CLEANING AND MAINTENANCE
Both new and used gloves should be thoroughly inspected, especially after cleaning treatment, before being worn to ensure no damage is present.
Gloves should not be left in contaminated condition if re-use is intended in which case gloves should be cleaned as far as possible, provided no serious hazard exists, before removal from hands.STORAGE
Ideally stored at in dry conditions in the original package, sheltered from direct light.

OBSOLESCENCE

When stored as recommended will not suffer change in mechanical properties from date of manufacture. Service life cannot be specified and depends on application and responsibility of user to ascertain suitability of the glove for its intended use.

GENERAL INFORMATION

These products are manufactured under a Quality System, which has been registered and meets the requirements of ISO 9001: 2000. None of the raw materials or processes used in the manufacture of these products is known to have any harmful effect on the wearer.

NOTE

The information contained herein is intended to assist the wearer in selection of Personal Protective Equipment. The results of physical and where appropriate chemical tests should also help in glove selection, however it is the responsibility of the user not the manufacturer to determine the glove suitability for the intended use.